Programmable, compact and robust
In standard or customized versions, our electronic control units for DC motors and BLDC motors meet a wide range of requirements. Each controller has a compact, robust design and can be connected via standard plug contacts. Rotation direction, rotation speed, ramps, dynamic braking, current supply, etc. can be controlled via programmable digital and analog inputs and outputs.
Motor control 06.34.006
| Item number | 06.34.006 |
|---|---|
| Item name | M3-2QB-5-12 |
| Motortype | DC |
| Digital input | 1 |
| Digital output | 1 |
| Analog input | 2 |
| Bus | nein |
| Overcurrent shutdown | |
| Rotating direction | Links-/Rechtslauf |
| Speed control | |
| Power limit | |
| Start ramp | |
| End ramp | |
| Dynamic breaking | |
| Max. power | 15 |
| Steady load current | 5 |
| Supply voltage of control circuit | 12 VDC, 24V Tolerant |
| Supply voltage load circuit | 12 (8-20) VDC |
| Voltage | 12 |
Technical description
The M3-2QB-5-12 module is a motor control unit for use in industrial environments. It ensures the switching on and off as well as the controlled driving of motors. The direction of rotation of the motor can be specified via a digital input. An internal trimmer can be used to set the maximum speed, which can be reduced again via an analog input to control the motor speed. The dynamic brake can be deactivated via a digital input. The module has an adjustable start and stop ramp and an adjustable fade-out time. The maximum motor current can be set via DIP switches and can be reduced again via an analog input. A digital input can be used to switch between the current cut-off and current limiting functions. The module can be switched to 100% PWM speed using a further digital input.
* The module does not have an internal 10V reference voltage for the analog inputs. For the full operating range of the analog input, the signal must reach 10V. An external power supply may be required.
Notices
Features:
-Reversal of direction of rotation
-Speed control (external)
-Current limitation (external)
-Current limitation/current cut-off
-Start ramp
-Stop ramp
fade-out time
Short-circuit detection
-Dynamic braking
For snapping onto DIN rails EN 50022 and EN 50035
Width: 22.5 mm
